Members' Forum

Thank you to everyone who made the donations to Marie Curie. Jim Poulton :) Hello James Poulton, Thank you for your donation. We're sending it straight to Marie Curie so you'll be making a difference very soon. A word from Marie Curie Thank you so much for your generous donation to Marie Curie. Than...

I fitted a bypass relay to my insignia for the same reason and it works well. Only time a bypass is no good is when you have parking sensors in the bumper because it cannot disable them.

I would retain the lead pipe and bond it to the main earth terminal. The lead pipe in the ground provides extra security if you experience a fault on the incoming service cable.

Have you seen:

http://www.ebay.co.uk/itm/LAND-ROVER-DE ... 342wt_1344

Cheers Jim

I think the rear A frame ball joint makes a loud bang if it is worn.

No points for guessing what I have been up to! Anyone know how the Flying Duck you get the clock and coin tray out of a Disco without breaking them? After approx 30 seconds of patience the red mist, a large screw driver and a hammer took a hold, ah well it's a good excuse to build a new dash centre...

Forget painting the roof it could do with a sunroof

Only place i know is Lenton and Smithson at the Grove, Harrogate. They are in the yard with Arrow self drive. See the link for their contact details: http://www.yell.com/ucs/UcsSearchAction.do?keywords=lenton&location=harrogate&scrambleSeed=18732500&searchType=&M=&bandedclarifyRe...

Isn't it a pleasure to own a land rover

It's on "novice building a wreck" You got my donut after the conversion! If it will not move I have a puller to remove the 3 bolt flange (Takes 15 mins and no fires :twisted: ) and will drop it off for you whenever. PM me with address Dave, Thanks for the offer to loan the puller but i ha...

£10 is ok for the prop. Can i collect it one evening this week?

Thanks Jim

Hi Bo I am after a propshaft if you have one for sale. Thanks to everyone for the info on how to change the donut to uj. I have now removed the prop, tightened a 8mm bolt into the flange and applied some heat. The pin hasn't moved yet but hopefully it will if i leave it over night with tension on it...

My Discovery propshaft donut disintegrated on the return journey from RHB .:cry: Please can someone help with the requirements of the conversion and the type of flange required to convert it to a standard UJ type. I think this topic has been covered before but i cannot find it. Any help greatly appr...

I am spectating with Ray and Henry on Sunday

Mark

My 200tdi 90 had the same problem and i had to replace the output flange and the seal because of the wear on the surface. I managed to change the seal without any special tools but as far as i can remember the seal is recessed into the casing.

Cheers Jim