Search found 9 matches
- Mon Apr 09, 2012 12:36 pm
- Forum: Technical Info
- Topic: 200Tdi Wastegate
- Replies: 4
- Views: 18248
Hi mark , yes should be short the arm is set at factory with correct pressure to open actuator then when set pressure removed and wastegate closed - to assembly on motor you can apply through a regulator air pressure . wind up from zero until actator moves cheak pressure when arm will engage , will ...
- Sun Apr 08, 2012 12:33 pm
- Forum: Technical Info
- Topic: 200Tdi Wastegate
- Replies: 4
- Views: 18248
Hi the arm in to the turbo should be free to move , dependent if the arm is stuck open or closed , if open you will have low boost pressure as pressure will be going past the waste gate , if fully closed then possible problems with fuel mix as pump will be set up for a set pressure at full boost 9-1...
- Fri Dec 02, 2011 10:39 pm
- Forum: Technical Info
- Topic: RRC clues...anyone????
- Replies: 10
- Views: 29547
- Tue Oct 25, 2011 2:48 pm
- Forum: Technical Info
- Topic: My Discovery 1 this time.
- Replies: 23
- Views: 71856
bad cranking problem
Had the same problem with my old 110, ok all year but turnend over slowly in winter turned out battery was for a v8 i.e to small not enought cranking amps replaced with a battey with more cranking power worked every time, should be at least over 800 cranking amps Note - do not look at a halfords bat...
- Tue Jul 19, 2011 9:53 pm
- Forum: Technical Info
- Topic: My mate Stu
- Replies: 3
- Views: 13500
- Mon Mar 28, 2011 8:35 pm
- Forum: Technical Info
- Topic: 14cux questions
- Replies: 26
- Views: 78193
- Fri Dec 31, 2010 10:40 pm
- Forum: Technical Info
- Topic: Megajolt Maps + info
- Replies: 6
- Views: 18178
- Thu Dec 30, 2010 6:10 pm
- Forum: Technical Info
- Topic: Megajolt Maps + info
- Replies: 6
- Views: 18178
- Mon Dec 27, 2010 12:14 pm
- Forum: Technical Info
- Topic: Megajolt Maps + info
- Replies: 6
- Views: 18178
Megajolt Maps + info
Have just finished building megajolt unit and am after a map for LPG and petrol for a 3.9 efi , also where can I get a bulkhead fitting to fit vacuum pipe to box of megajolt (v2 model map sensor in box), can you test vr sensor with out it connected up .