Installation of Plasma rope to winch drum
Installation of Plasma rope to winch drum
Hi all
Can anyone help me with instructions to install a plasma rope. I am not sure how the crimp with the hole in attaches to the drum.
Cheers Jim
Can anyone help me with instructions to install a plasma rope. I am not sure how the crimp with the hole in attaches to the drum.
Cheers Jim
Jim Poulton
- davew
- Chairman
- Posts: 2243
- Joined: Fri Jan 05, 2007 8:54 pm
- Location: Knaresborough
- Full Name: Dave White
You have an 8274 if I remember correctly ?
If so, you don't use the crimp, just feed the end of the rope through the hole in the drum and either tie a knot in it or use a cable tie to form it into a loop, a lot easier to take the rope off again !. (there shouldn't be any real load on it anyway).
If you're using a different winch then the crimp goes onto a bolt in the side of the drum flange.
If so, you don't use the crimp, just feed the end of the rope through the hole in the drum and either tie a knot in it or use a cable tie to form it into a loop, a lot easier to take the rope off again !. (there shouldn't be any real load on it anyway).
If you're using a different winch then the crimp goes onto a bolt in the side of the drum flange.
Rope installation
Hi Dave
Thanks for the advice, thought i'd better check before altering the rope to fit especially after parting with lots of£££££ notes.
Cheers Jim
Thanks for the advice, thought i'd better check before altering the rope to fit especially after parting with lots of£££££ notes.
Cheers Jim
Jim Poulton
Who is online
Users browsing this forum: No registered users and 19 guests