Im having a problem reprogramming key fob after changing battery in fob.
r las put some thing on a-se about face book last night
but non of the ideas worked, so if any one has an idea please post below
Cheers
Rod
The handset signals must be synchronized to the CCU. The synchronization
will be lost if the power supply to the vehicle or the handset is lost.
Synchronization can be reprogrammed by pressing the handset lock button five
times in quick succession with the ignition off. Alternatively, the ignition can be
switched to position II with the handset attached to the key ring, this will
automatically reprogram the synchronization. This is achieved by means of a
circular transponder antenna located around the outside diameter of the
ignition switch. For this to happen, the transmitter must be within 70 mm of the
ignition barrel.
Rod wrote:Im having a problem reprogramming key fob after changing battery in fob.
r las put some thing on a-se about face book last night
but non of the ideas worked, so if any one has an idea please post below
Cheers
Rod
Users browsing this forum: No registered users and 309 guests