Club Forum | Yorkshire Off Road Club

Waterproofing P38.......

3 posts • Page 1 of 1

bandiflip: Posts: 1166; Joined: Sat Sep 13, 2008 10:14 pm; Location: Bradford; Full Name: phil johnson

Waterproofing P38.......

Quote

Postby bandiflip » Wed Mar 18, 2009 12:55 am

Hey chaps.....Am just on with sorting my P38 for a bit of deep water,Snorkel is just about ready for bolting on,Axle and transmission breathers are all in place but Has anyone got any suggestions for waterproofing the ECU which is unfortunately located under the bonnet.
rather than extend the wiring (which could be asking for trouble) i would rather seal the ECU.....ALL suggestion are MOST welcome....I thank you !

do you know the meaning of Nemesis ???

Top

olzook: Posts: 386; Joined: Mon Apr 14, 2008 8:22 am; Location: Whalley; Full Name: oliver heselton

Quote

Postby olzook » Wed Mar 18, 2009 8:21 am

I used to have a bob-tailed rangie and think the previous owner had a contract with Lakeland Plastics as everything electrical was housed in various sized butty boxes with loads of silcone to seal :roll:

Seemed to work :shock:

Dont know if some of these things are supposed to breath though ?

Top

TwoSheds: Posts: 1092; Joined: Thu Jan 18, 2007 8:01 pm; Location: M1/M62; Full Name: Roger Watkinson

Quote

Postby TwoSheds » Wed Mar 18, 2009 12:55 pm

olzook wrote:Don't know if some of these things are supposed to breath though ?

I would have thought that if it can survive under-bonnet on a hot day in Saudi then being sealed in a butty-box would be fine..
The only electronic things I know of that need to breath are 'normal' lambda sensor (not the kind they use on Land Rovers)...

...

...

(I am awaiting correction)...