In preparation for rebuilding the front axle internals with the new halfshafts I've been thinking about how to sort out the end float and I've got a few questions:
1. How crucial is it to have endfloat within the tolerances set in the spec (according to Haynes in should be 0.12 - 0.25mm).
2. I've not got a dial gauge so could I just use feeler gauges?
3. Any other tips for setting endfloat?
Need to know what's broken and maybe how to fix it ? Post here
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests
Copyright © 2018 Yorkshire Off Road Club